Teaching purposes
The motor drive system training platform is based on Electric Vehicle E5 original car motor drive system and ABS brake system. The motor drive system adopts three-phase drive motor supporting single-speed step-less speed change, and the training platform has intelligent fault assessment system. It is suitable for the teaching of the structure principle and maintenance training of new energy pure electric vehicles in vocational and technical colleges, general education colleges and training institutions.
Product features
1) Modular Design
The motor drive system and ABS brake system adopt modular design, which will drive the original car drive motor, heat pump, loose kettle, front and rear drive wheels, ABS control unit, low-voltage iron battery, accelerator pedal and shift lever. The assembly and assembly instrument, EPB brake switch and start switch are installed and fixed on the professional base and the operation control panel. The base is designed with low-voltage signal lines and high-voltage output line card slots. The high-voltage lines are installed with safety signs for teaching. Identification.
2) Keep The Original Car Line Connection:
The motor drive system training platform is connected by the original car wiring harness. Parallel double plugs for measurement are installed next to each harness connector, which greatly reduces the line loss during signal detection. Parallel plug The pin number is marked, and the number corresponds to the original circuit diagram pin number, which satisfies the need for low-voltage signal detection of pure electric vehicle motor drive system, combination meter and brake system during training. The relevant signals of each control unit are connected to the vehicle controller through the original vehicle harness, which satisfies the data diagnosis and dynamic data stream reading function during the training process.
3) Intelligent Fault Assessment System:
Consists of two independent systems: the teacher fault setting terminal and the student answering terminal. The system is installed on the mobile terminal. The teacher can connect with the fault setting module of the training platform to set the fault with the mobile teaching terminal connected to the WI-FI. After the fault setting is completed, the students use the mobile learning terminal to perform the assessment, and the scores after the assessment are automatically stored in the equipment execution module, so that the teacher can query the results of each student. The intelligent fault assessment system also has password management, fault name editing, assessment time setting, fault type setting and fault recovery testing function.
4) Product Process Standard:
The Base Frame Of The Equipment is constructed by two integrated aluminum alloy profiles of 40mm×40mm and 40mm×80mm. It is resistant to oil and corrosion and easy to clean. The table top is covered with 20mm thick color high-density composite board. The electrical installation part is strictly in accordance with The EU CE electrical certification standard is implemented and manufactured. The whole wiring harness adopts the connector with the safety strength to reach the IP64 military level. The wire harness damage caused by long-term training can be directly replaced in sections, eliminating the worries.
